Keep us running!
Order HD Helmet HERO at GoPro.com
 
Next Event: AAS Round 1
  
  
Home » Bay Area Autocross Forum » Tech/Setup » Trailer Axle Alignment specs (Light duty single axle 4x6 utility trailer)
Trailer Axle Alignment specs [message #122692] Mon, 29 April 2019 15:52 Go to previous message
atcovan is currently offline  atcovan   
Messages: 3108
Registered: December 2006
Location: North Highlands
Top Time of Day
CONTRIBUTOR

From: *lightspeed.frokca.sbcglobal.net
I installed a new and heavier 2000lb axle for my luggage hauler. I took out the ridiculous amount of positive camber and got it to zero. I doubt any load will require camber. Now, I set the toe to a total of 1/8" toe-in. Am I good to go, or should I try to get it closer to dead straight? I want best tire wear, tracking stability and pull efficiency.

Jim
 
Read Message
Read Message
Read Message
Previous Topic: Threaded bushing for oil filter
Next Topic: The list for "Where to get tire?"
Goto Forum:
  


Current Time: Wed Jun 26 06:03:40 PDT 2019

Total time taken to generate the page: 0.01063 seconds