Keep us running!
Order HD Helmet HERO at
Next Event: AAS Round 1
Home » Bay Area Autocross Forum » Tech/Setup » Threaded bushing for oil filter
Threaded bushing for oil filter [message #122524] Thu, 10 January 2019 17:13
atcovan is currently offline  atcovan   
Messages: 3108
Registered: December 2006
Location: North Highlands
Top Time of Day

From: *
I need a pair of threaded bushings to facilitate oil filter installation. The filter threads are 22 x 1.5, but the mounting is 3/4" x 16. If I had a lathe, I could easily make them. Anyone out there willing to make me a set of two?

ID... 3/4" x 16
OD... 22mm x 1.5

Overall length 2" each, or make a single 4.25" long and I'll cut to size.

Aluminum or steel.

Previous Topic: Flat Tappet Camshaft Longevity and Your Lawn Equipment
Next Topic: Trailer Axle Alignment specs
Goto Forum:

Current Time: Sun May 31 03:59:26 PDT 2020

Total time taken to generate the page: 0.00889 seconds